![]() ![]() The blank should be flush with the brass tube on both ends. Sanding Blanks to Length Using a belt or disc sander, square the ends of the brass tube/wood blank. If you find that CA glue is not providing adequate bonding, an alternative is any two part epoxy type glue. Rotate the tube as you insert it to ensure maximum surface coverage of glue. Gluing Blanks to Tubes Rough the brass tube’s surface with a fine grit sandpaper and use a quick drying CA type glue to secure the brass tubes into the blanks. You may also chuck and drill the stock on your lathe. Before you start to drill be sure that your blank is at 90° to the drill press table. 1 are easily drilled using a clamp and a drill press (FIG. The center of the blank can be located at the intersection of diagonal lines, drawn from opposite corners. ![]() Drilling Blanks Center and bore a hole through your stock as specified in the Project Instructions on the opposite side. For your safety, be sure that the blanks are solid and have no holes, checks or other defects. Cutting Blanks Cut wooden blanks to the size specified in the enclosed instructions. The following is general in nature, please refer to the instruction sheet on the opposite side for specific dimensions and sizes for your project. Using cut-offs and shorts, the type everyone saves but doesn’t know what to do with, you’ll find yourself making handsome, custom woodturning projects which are great for gifts or for sale. 77C74 Wall Street II Letter Opener Kit Product #150549, 150550 12/31/09 General Instructions Whether you’re a novice turner or a pro, you’ll find these projects are all quick and easy to make. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |